I got my Ender 3 in 2016 and although it has produced satisfactory results it needed constant tinkering and I had to deal with bed levelling and clogs.

My Neighbours asked me what I wanted for my Birthday and Christmas. I had been looking at a lot of YouTube videos and they were all pointing me towards the BambuLabs A1. And with Black Friday it was too good a deal to pass up.

All I can say is, believe the hype.

It is easy to set up and the print results are amazing. With the 0.2 hotend and highest print quality you are looking at a near resin quality. And if you apply the Three Foot Rule you would never know.

For very fine details resin is King. But dealing with the clean-up and the toxic waste is a right pain.